Ospf V3; Ospfv3 Basic Settings; Interface; Figure 7-125. Ospfv3 Basic Settings Page - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
OSPF V3
The OSPFv3 link allows you to configure the OSPFv3 protocol through the following
pages:
•
"OSPFv3 Basic Settings" on page 7-141
•
"Interface" on page 7-142
•
"Area" on page 7-144
•
"OSPF V3 External Aggregation" on page 7-145
OSPFv3 Basic Settings
Clicking the B
ASIC
(Figure
7-125). The parameters for this page are shown in
Table 7-98. OSPFv3 Basic Settings Page Parameters
Parameter
OSPFv3 Status
Router ID
Autonomous System
Border Router Status
Area Border Router
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-125. OSPFv3 Basic Settings Page
S
tab brings up the OSPF
ETTINGS
Description
This parameter enables or disables OSPFv3 administratively.
This parameter uniquely identifies the router in the Autonomous System.
This parameter specifies the router as Autonomous System border router.
This parameter specifies the router as an area border router.
3 B
V
ASIC
7-141
S
page
ETTINGS
Table
7-98.
Advertisement
Table of Contents
