Dvmrp; Dvmrp Basic Settings; Figure 7-165. Dvmrp Basic Settings Page; Table 7-133. Dvmrp Basic Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
DVMRP
The DVMRP page allows you to configure the DVMRP protocol using the following
pages:
•
"DVMRP Basic Settings" on page 7-185
•
"Interfaces" on page 7-186
DVMRP Basic Settings
Clicking the B
ASIC
(Figure
7-165). The parameters for this page are shown in
Table 7-133. DVMRP Basic Settings Page Parameters
Parameter
DVMRP Status
Prune Lifetime (Seconds)
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-165. DVMRP Basic Settings Page
S
tab brings up the DVMRP B
ETTINGS
Description
DVMRP can be enabled or disabled in the switch using this field.
This parameter represents the Prune Life Time Configuration value.
ASIC
7-185
S
page
ETTINGS
Table
7-133.
Advertisement
Table of Contents
