IP Authorized Manager
Clicking the IP A
(Figure
7-17), which allows you to configure allowed management nodes for managing
the switch. The parameters for this page are shown in
Table 7-7. IP Authorized Manager Page Parameters
Parameter
IP Address
Subnet Mask
Port List (Incoming)
VLANs Allowed
Services Allowed
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-17. IP Authorized Manager Page
M
tab brings up the IP A
UTH
ANAGER
Description
This parameter specifies the IP address of the manager. An address
0.0.0.0 indicates "Any Manager".
This parameter specifies the sub-network mask for the specified IP
address.
This lists the port through which the manager can access this switch. Ports
can be comma separated or provided as a range (for example 1,2,3 or 1-3
or 1,2-3).
This parameter specifies the VLANs through which the manager can
access this switch. VLANs can be comma seperated or provided as range
(for example 1,2,3 or 1-3 or 1,2-3).
These control buttons are used to indicate the service type, and can be
one or more of the following: T
UTHORIZED
Table
, SSH, HTTP, HTTPS, SNMP or ALL.
ELNET
7-21
M
page
ANAGER
7-7.