Prefix Settings; Figure 7-105. Prefix Configuration Page; Table 7-79. Prefix Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-78. Address Profile Settings Page Parameters (Continued)
Parameter
Preferred Time
Valid Time
Valid Flag
Preferred Flag
Prefix Settings
Clicking the P
REFIX
(Figure
7-105). The parameters for this page are shown in
Table 7-79. Prefix Configuration Page Parameters
Parameter
Interface VLAN ID
Prefix
Prefix Length
Prefix Profile ID
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter specifies the Preferred Lifetime of the prefix address that
uses this profile.
This parameter indicates the Valid Lifetime of the prefix address that uses
this profile.
This parameter specifies if the Valid Lifetime Flag is Variable or Fixed.
This parameter specifies if the Preferred Lifetime Flag is Variable or Fixed.
Figure 7-105. Prefix Configuration Page
S
tab brings up the P
ETTINGS
Description
This parameter specifies the index of the VLAN Interface.
This parameter indicates the IPv6 address prefix to be advertised in RA.
This parameter indicates the P
This parameter specifies index to the IPv6 address profile table.
C
REFIX
ONFIGURATION
L
REFIX
ENGTH
7-119
page
Table
7-79.
(in bits).
Advertisement
Table of Contents
