Port Configuration; Figure 7-78. Cist Settings Page; Table 7-55. Cist Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Port Configuration
Clicking the P
ORT
which sets the configuration per Port related to MSTP. The parameters for this page are
shown in
Table
Parameter
Port
Admin Status
Priority
Path Cost
Protocol Migration
Edge Status
Point-to-Point Status
Hello Time (Seconds)
Figure 7-78. CIST Settings Page
C
tab brings up the CIST S
ONFIGURATION
7-55.
Table 7-55. CIST Settings Page Parameters
Description
This parameter specifies the port identifier.
This parameter specifies the MSTP protocol status that can be enabled/
disabled on the particular port.
This parameter specifies the port priority used in role selection.
This parameter specifies the path cost associated with this port.
This parameter controls the migration among MSTP, RSTP and STP
protocols, if the other side of the switch runs a different mode. Migration
takes place only if this is enabled.
This parameter must be configured if the corresponding port is an edge
port.
This parameter allows you to configure the ports explicitly as point-to-point
(Force true), as a non-point-to-point port, or leave the decision to be made
dynamically (from the AL or MAC layer).
This parameter specifies the administrative value of Hello Time for the port.
7-90
page
(Figure
ETTINGS
7-78),
Advertisement
Table of Contents
