Figure 7-150. Igmp Snooping Interface Configuration Page; Table 7-120. Igmp Snooping Interface Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Table 7-119. IGMP Snooping Timer Configuration Page Parameters (Continued)
Parameter
Report Forward Interval
(Secs)
Group Query Interval
(Secs)
IGMP Snooping Interface
Figure 7-150. IGMP Snooping Interface Configuration Page
Clicking the
INTERFACE
C
ONFIGURATION
parameters. The parameters for this page are shown in
Table 7-120. IGMP Snooping Interface Configuration Page Parameters
Parameter
VLAN ID
IGMP Snooping Status
Operating Version
Description
This parameter specifies the interval within which the next report
messages for the same multicast group will not be forwarded. The default
value is 5-seconds.
This parameter specifies the interval within which the switch sends a group
specific query on a port when an IGMPv2 leave message is received. The
default value is 2-seconds.
C
ONFIGURATION
page
(Figure
7-150), which configures IGMP snooping interface specific
Description
This parameter specifies the VLAN ID for which the configuration is to be
performed.
This parameter specifies the status of IGMP snooping in the Switch, which
can be enabled or disabled for a specific VLAN.
This parameter specifies the operating version of the IGMP snooping
switch for a specific VLAN.
tab brings up the IGMP S
Table
7-170
I
NOOPING
NTERFACE
7-120.
Advertisement
Table of Contents
