Security Settings; Figure 7-113. Rip Security Settings Page; Table 7-86. Rip Security Setting Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Security Settings
Clicking the S
ECURITY
parameters for this page are shown in
Table 7-86. RIP Security Setting Page Parameters
Parameter
IP Address
Authentication Type
Authentication Key
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-113. RIP Security Settings Page
tab brings up the RIP S
Table
Description
This parameter displays the active RIP interfaces. You can select the
interface for which you want to configure authentication.
This parameter specifies the authentication type. You can choose No
Authentication, or Simple Password, or the md5 authentication type.
This parameter specifies the key used for authentication if the
authentication type is other than No Authentication.
7-127
S
page
ECURITY
ETTING
7-13.
(Figure
7-113). The
Advertisement
Table of Contents
