Figure 7-62. Vlan Port Settings Page; Table 7-43. Vlan Basic Settings Page Parameters - Supermicro SuperBlade Series User Manual

Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Hide thumbs Also See for SuperBlade Series:
Table of Contents

Advertisement

Table 7-43. VLAN Basic Settings Page Parameters

Parameter
Garp System Control
Learning Mode
VLAN Version
Maximum VLAN ID
Maximum Supported
VLANs
Number of VLANs in the
System
MAC Based on All Ports
Port and Protocol Based on
all Ports
In addition, the B
(Customer /Provider) and the priority for tunneled STP BPDUs. When you configure
B
M
RIDGE
ODE TO
classification on all ports must be disabled.
Port Settings
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter starts or shuts down GARP in the switch.
This parameter specifies the Learning Mode (Independent, Shared, Hybrid
or VLAN Learning).
This parameter specifies the VLAN version supported.
This parameter specifies the largest (4094) valid VLAN ID, which this
switch can accept, above which all will be discarded.
This parameter specifies the maximum number of VLANs that this device
can scale.
This parameter specifies the active number of VLANs configured in the
device.
This parameter enables or disables the per Port MAC based classification.
This parameter enables or disables the per Port Protocol based
classification.
S
page provides the configuration3 of Bridge Mode
ASIC
ETTINGS
P
, the Port Protocol based classification and MAC-based
ROVIDER

Figure 7-62. VLAN Port Settings Page

7-73

Advertisement

Table of Contents
loading

Table of Contents