Tacacs+ Server Configuration; Figure 7-16. Tacacs+ Server Configuration Page; Table 7-6. Tacacs+ Server Configuration - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
TACACS+ Server Configuration
Clicking the TACACS+ S
page
(Figure
7-16), which allows you to configure TACACS servers. The parameters for
this page are shown in
Table 7-6. TACACS+ Server Configuration Page Parameters
Parameter
IP Address
Port
Single Connection
Timeout
Secret Key
Figure 7-16. TACACS+ Server Configuration Page
tab brings up the TACACS+ S
ERVERS
Table
7-6.
Description
This parameter specifies the IP address of the TACACS server.
Use this parameter to specify the
Specify Yes or No for a single TCP connection. If Yes, it establishes only a
single TCP connection with a given TACACS server.
The time for which the switch will wait for a response from the TACACS
server before closing the connection is specified with this parameter. It is
configurable in seconds, with the default as 5-seconds.
This parameter specifies the encryption key for the given TACACS server.
TCP port for TACACS protocol.
7-20
C
ERVER
ONFIGURATION
Advertisement
Table of Contents
