Ospf; Ospf Basic Settings; Area; Figure 7-117. Ospf Basic Settings Page - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
OSPF
The OSPF link allows you to configure the OSPF protocol through the following pages:
•
"OSPF Basic Settings" on page 7-132
•
"Area" on page 7-133
•
"Interface" on page 7-134
•
"Virtual Interface" on page 7-135
•
"OSPF Neighbor" on page 7-136
•
"OSPF RRD Route Configuration" on page 7-137
•
"OSPF Area Aggregation" on page 7-138
•
"External Aggregation" on page 7-139
OSPF Basic Settings
Clicking the B
ASIC
(Figure
7-117). The parameters for this page are shown in
Table 7-90. OSPF Basic Settings Page Parameters
Parameter
OSPF Status
Router ID
Figure 7-117. OSPF Basic Settings Page
S
tab brings up the OSPF B
ETTINGS
Description
This parameter specifies the global status of the protocol in the switch.
This parameter specifies the router identifier.
ASIC
7-132
S
page
ETTINGS
Table
7-90.
Advertisement
Table of Contents
