Pim Rp Set Information; Figure 7-209. Pim Rp Information Page; Table 7-177. Pim Rp Information Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
PIM RP Set Information
Clicking the RP S
which displays PIM RP information. The parameters for this page are shown in
Table
7-177.
Table 7-177. PIM RP Information Page Parameters
Parameter
Group
Mask
Candidate RP
Hold Time
Expiry Time
Component
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-209. PIM RP Information Page
I
tab brings up the PIM RP I
ET
NFO
Description
This parameter specifies the group address.
This parameter specifies the mask.
This parameter specifies the candidate RP.
This parameter specifies the Hold time in seconds.
This parameter specifies the expiry time in seconds.
This parameter specifies the component identifier.
NFORMATION
7-245
page
(Figure
7-209),
Advertisement
Table of Contents
