Interfaces; Figure 7-111. Rip Interface Page; Table 7-85. Rip Interface Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Interfaces
Clicking the I
NTERFACE
parameters for this page are shown in
Parameter
Interface
IP Address
Status
Split Horizon
Default Route Installation
Send Version
Receive Version
Route Age Timer
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-111. RIP Interface Page
tab brings up the RIP I
Table 7-85. RIP Interface Page Parameters
Description
This parameter specifies the Interface ID for which RIP needs to be
configured.
This parameter specifies the IP address of the RIP interface.
This parameter specifies the admin status of the interface.
This parameter specifies the operational status of Split Horizon in the
system.
This parameter specifies whether Default Route Installation can be done or
not.
This parameter allows selecting the RIP packets sent to be compatible to
either RIPV1, RIP1 Compatible or RIPv2.
This parameter is similar to S
RIP packets to be received as either RIPV1, RIPV2, both RIPv1 and RIPv2
or None.
This parameter specifies the time interval after which the routes will be
flushed.
page
NTERFACE
Table
7-85.
V
END
ERSION
7-125
(Figure
7-111). The
, but it allows you to choose the
Advertisement
Table of Contents
