Superblade Network Modules User's Manual
System Settings
The following pages can be accessed through the System Settings link:
•
"System Settings" on page 7-10
•
"System Version" on page 7-12
System Settings
Clicking the S
YSTEM
This page provides system related information and also helps you configure system
specific parameters.
Parameter
Device Name
IP address mode
Subnet Mask
SNMP Engine ID
Device contact
Device Location
PIM Mode
Figure 7-8. System Settings Page
I
tab brings up the S
NFORMATION
Table 7-2
lists the parameters found on this page.
Table 7-2. System Information Page Parameters
Description
A configurable name can be entered into this field for the switch.
Either Manual or Automatic mode can be set for this parameter.
Use this parameter to configure the subnet mask.
This configures the SNMP Engine Identifier.
Use this parameter to change the device contact.
Use this parameter to change the device location.
Use this to configure the PIM status of the switch.
YSTEM
7-10
S
page
(Figure
ETTINGS
7-8).