Igmp; Basic Settings; Interface Configuration; Group Information - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
IGMP
The IGMP page allows you to configure the IGMP protocol. The IGMP protocol in the
switch can be configured through the following pages:
•
"Basic Settings" on page 7-175
•
"Interface Configuration" on page 7-176
•
"Group Information" on page 7-177
•
"Source Information" on page 7-178
Basic Settings
Clicking the IGMP C
(Figure
7-155), whose single parameter allows you to enable or disable IGMP in the
switch.
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-155. IGMP Configuration Page
tab brings up the IGMP C
ONFIGURATION
7-175
page
ONFIGURATION
Advertisement
Table of Contents
