Ntp Settings; Figure 7-46. Ntp Settings Page; Table 7-34. Ntp Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
NTP Settings
Clicking the NTP link brings up the NTP S
the Network Time Protocol (NTP). The parameters for this page are shown in
Table
7-34.
Parameter
NTP Client Settings
NTP Status
Receive Server Update
Timezone Settings
Hour Offset
Minutes Offset
NTP Servers
Server IP Address
Key
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-46. NTP Settings Page
Table 7-34. NTP Settings Page Parameters
Description
This field enables or disables NTP in the switch. Configure the NTP
S
section to enable NTP.
ERVERS
The value for this parameter could be Broadcast or Unicast. To process the
broadcast NTP updates from the server, choose the Broadcast option.
This parameter allows you to enter an hour offset from GMT for local time.
This parameter allows you to enter a minutes offset (after hour offset) from
GMT for local time.
Use this parameter to enter the NTP server IP address.
Choose the key from the configured list. These keys are configurable in
this page in the NTP S
page
(Figure
ETTINGS
K
section's fields.
ERVER
EYS
7-53
7-46), which configures
Advertisement
Table of Contents
