Webgui Settings; Figure 7-25. Web Gui Settings Page; Table 7-14. Web Gui Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
WEBGUI Settings
Clicking the W
EB
which displays all basic Web GUI settings. The parameters for this page are shown in
Table
7-14.
Parameter
Session timeout
Statistics Refresh Timer
Session Privilege
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-25. Web GUI Settings Page
S
link brings up the W
ETTINGS
Table 7-14. Web GUI Settings Page Parameters
Description
This timeout value is used to automatically logout inactive user sessions.
The default value is 5-minutes (600-seconds).
The statistics pages (grouped under "Statistics" node in left side tree) can
be set to auto refresh based on this Statistics Refresh Timer. The default
value zero means no auto refresh by default.
This displays the current privilege level of the logged in user. You can
choose to enter another privilege level using this configuration if you have
the Enable Password for the required privilege levels. The Enable
Passwords for different levels are configurable in the
Security
web page.
GUI S
EB
ETTINGS
7-31
page
(Figure
7-25),
Management
Advertisement
Table of Contents
