Figure 7-148. Igmp Snooping Configuration Page; Table 7-118. Igmp Snooping Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
IGMP Snooping Configuration
Clicking the B
ASIC
(Figure
7-148), which allows you to configure IGMP snooping parameters. The
parameters for this page are shown in
Table 7-118. IGMP Snooping Configuration Page Parameters
Parameter
System Control
IGMP Snooping Status
Operational Status
Proxy Reporting
Snooping Mode
Report Forwarding
Figure 7-148. IGMP Snooping Configuration Page
S
tab brings up the IGMP S
ETTINGS
Description
This parameter Starts or Shutsdown IGS in the switch.
This parameter enables or disables IGMP snooping globally in the switch.
To enable IGS, GMRP status must be Disabled.
This parameter enables or disables IGMP snooping operationally in the
switch. To enable IGS, GMRP status must be Disabled.
This parameter indicates whether the proxy reporting in the IGMP
snooping switch is to be enabled or disabled.
This parameter specifies the IGMP snooping multicast forwarding mode,
which can be configured using the Destination IP Address or the
Destination MAC Address.
This parameter specifies whether the IGMP reports are forwarded on all
ports or only on router ports.
NOOPING
Table
7-118.
7-168
C
page
ONFIGURATION
Advertisement
Table of Contents
