Loopback Basic Settings; Figure 7-99. Loopback Basic Settings Page; Table 7-73. Loopback Basic Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
LoopBack Basic Settings
Clicking the L
OOP
(Figure
7-99), which allows you to configure loopback IP interfaces. The parameters for
this page are shown in
Table 7-73. LoopBack Basic Settings Page Parameters
Parameter
LoopBack Interface
Interface Type
Interface Status
IP Address
Subnet Mask
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-99. LoopBack Basic Settings Page
B
S
tab brings up the L
ACK
ETTINGS
Table
7-73.
Description
This parameter is the name of the loopback interface getting created.
This parameter is always the loopback for this configuration.
This parameter for the I
This parameter specifies the IP address for this loopback interface.
This parameter specifies the subnet mask for this loopback interface.
B
OOP
ACK
S
NTERFACE
TATUS
7-113
B
S
ASIC
ETTINGS
can be set to Up or Down.
page
Advertisement
Table of Contents
