Filters; Figure 7-116. Rip6 Filter Configuration Page - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Table 7-88. RIP6 Interface Configuration Page Parameters (Continued)
Parameter
Prof Horizon
Per-Updt Timer
Trig-Dly Time
Route Age Time
Garbage Timer
Filters
Clicking the F
ILTERS
The parameters for this page are shown in
Description
This parameter specifies the operational status of Profile Horizon in the
system.
This parameter specifies the time interval between successive RIP6
updates.
This parameter indicates the time interval in seconds by which further
triggered updates are delayed, after one triggered update is sent.
This parameter specifies the time interval after which, the routes are
flushed.
This parameter specifies the time interval after which, the invalid routes are
removed from the routing table.
Figure 7-116. RIP6 Filter Configuration Page
tab brings up the RIP6 F
C
ILTER
ONFIGURATION
Table
7-89.
7-130
page
(Figure
7-116).
Advertisement
Table of Contents
