Filters; Unicast Filters; Figure 7-93. L2 Unicast Filter Configuration Page; Table 7-68. L2 Unicast Filter Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Filters
The Filters link allows you to configure Layer 2 packet filtering.
The Layer 2 packet filtering management has the following configuration pages:
•
"Unicast Filters" on page 7-107
•
"Multicast Filters" on page 7-108
Unicast Filters
Figure 7-93. L2 Unicast Filter Configuration Page
Clicking the U
NICAST
(Figure
7-22), which sets the filter configuration to control the unicast packets that the
switch needs to process. The parameters for this page are shown in
Table 7-68. L2 Unicast Filter Configuration Page Parameters
Parameter
FDB ID
MAC Address
Receive Port
Chapter 7: Layer 2/3 Ethernet Switch Firmware
F
tab brings up the L2 U
ILTERS
Description
This parameter specifies the forwarding database ID.
This parameter specifies the destination MAC address of the received
packet.
This parameter specifies the port on which the packet was received.
7-107
F
C
NICAST
ILTER
ONFIGURATION
Table
page
7-13.
Advertisement
Table of Contents
