Rate Limiting; Figure 7-60. Rate Limiting Page; Table 7-42. Rate Limiting Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Rate Limiting
Clicking the R
ATE
allows you to configure rate limiting for the port interface. The parameters for this page
are shown in
Table
Parameter
Port
The following parameters are configurable for Ingress Rate Limiting.
DLF Level
Broadcast Level
Multicast Level
The following parameters are configurable for Egress Rate Limiting.
Egress Port Rate Limit
Egress Port Burst Size
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-60. Rate Limiting Page
L
tab brings up the R
IMITING
7-42.
Table 7-42. Rate Limiting Page Parameters
Description
This displays the port number.
This parameter allows you to specify the destination lookup failure packets
per second.
This parameter allows you to specify the broadcast packets per second.
This parameter allows you to specify the multicast packets per second.
This parameter allows you to specify the egress limit of packets per
second.
This parameter allows you to specify the egress limit of packet burst size.
L
ATE
IMITING
7-71
page
(Figure
7-60), which
Advertisement
Table of Contents
