Table of Contents
Advertisement
Rack Configuration
The SSE-C3632S/R is designed to be mounted on a standard 19'' rack.
ventilation for the rack.
•
Every device in the rack will generate heat during operation, therefore vent and fans must
be provided for an enclosed rack, and devices should not be stacked closely.
•
When mounting devices in an open rack, care should be taken to prevent the rack frame
from obstructing the switch ventilation openings. Be sure to check the positioning of the
switch after installation to avoid the aforementioned.
Caution: If a standard 19'' rack is not available, the SSE-C3632S/R can be placed on a clean level
desktop. Leave a clearance of 100mm around the switch for ventilation, and do not place anything on
top of the switch.
3.2 Installation Notice
•
Read through the installation instruction carefully before operating on the system. Make
sure the installation materials and tools are prepared. And make sure the installation site
is well prepared.
•
During the installation, users must use the brackets and screws provided in the accessory
kit. Users should use the proper tools to perform the installation. Users should always wear
antistatic uniform and ESD wrist straps. Users should use standard cables and connecters.
•
After the installation, users should clean the site. Before powering on the switch, users
should ensure the switch is well grounded. Users should maintain the switch regularly to
extend the lifespan of the switch.
•
A statement indicating the location of a readily accessible disconnect device shall be
incorporated in the building installation wiring.
SSE-C3632S/SR Switch Installation Guide
Page 28
Please ensure good
Advertisement
Table of Contents
