Figure 7-157. Igmp Group Configuration Page; Table 7-125. Igmp Group Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Group Information
Clicking the G
ROUP
(Figure
7-157). The parameters for this page are shown in
Table 7-125. IGMP Group Configuration Page Parameters
Parameter
Interface
Group Address
Source Address
Filter Mode
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-157. IGMP Group Configuration Page
I
tab brings up the IGMP G
NFORMATION
Description
This parameter specifies the interface index.
This parameter specifies the IP multicast group address.
represents the IP Source address.
This parameter
NOTE: Source configuration is allowed only when the operating version is
v3 on this interface.
This parameter specifies the F
M
ILTER
ODE
7-177
C
ROUP
ONFIGURATION
Table
7-125.
.
page
Advertisement
Table of Contents
