Figure 7-119. Ospf Interface Configuration Page; Table 7-92. Ospf Interface Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Interface
Clicking the I
NTERFACE
(Figure
7-119). The parameters for this page are shown in
Table 7-92. OSPF Interface Configuration Page Parameters
Parameter
Interface
Area ID
Priority
Authentication Type
MD5 Key ID
Authentication Key
IP Address
Figure 7-119. OSPF Interface Configuration Page
tab brings up the OSPF I
Description
This parameter specifies the interface index of the port.
This parameter indicates the 32-bit integer uniquely identifying the area to
which the interface connects.
This parameter specifies the priority of this interface, which is used in the
DR election algorithm.
This parameter allows you to choose MD5, Simple Password or None as
the authentication type.
This parameter specifies the secret key used to create the message digest
appended to the OSPF packet, if the authentication type is MD5.
This parameter specifies the key required for authentication, if
authentication is enabled on this interface.
This parameter specifies the IP Address of the OSPF interface.
NTERFACE
7-134
C
page
ONFIGURATION
Table
7-92.
Advertisement
Table of Contents
