Snmp Target Address Settings; Figure 7-31. Snmp Target Address Settings Page; Table 7-19. Snmp View Tree Settings Page Parameters; Table 7-20. Snmp Target Address Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-19. SNMP View Tree Settings Page Parameters
Parameter
View Name
SubTree
Mask
View Type
Storage Type
SNMP Target Address Settings
Figure 7-31. SNMP Target Address Settings Page
Clicking the T
ARGET
(Figure
7-31), which configures SNMP target address parameters. The parameters for
this page are shown in
Table 7-20. SNMP Target Address Settings Page Parameters
Parameter
Target Name
Target IP Address
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter specifies a V
This parameter specifies a tree OID.
This parameter specifies an OID mask.
This parameter specifies whether a V
Use this parameter to specify whether the S
non-volatile.
A
tab brings up the SNMP T
DDRESS
Table
7-20.
Description
This parameter specifies a T
The T
IP A
ARGET
DDRESS
generation of SNMP operations.
N
string.
IEW
AME
T
IEW
ARGET
N
as a unique identifier.
ARGET
AME
specifies a target address to be used in the
7-37
is Included or Excluded.
YPE
T
is volatile or
TORAGE
YPE
A
S
DDRESS
ETTINGS
page
Advertisement
Table of Contents
