PIM
The PIM link allows you to perform PIM related configuration through the following
pages:
•
"Basic Settings" on page 7-179
•
"Component" on page 7-180
•
"Interfaces" on page 7-181
•
"Candidate RPs" on page 7-182
•
"Threshold" on page 7-183
•
"Static RP" on page 7-184
Basic Settings
Clicking the B
ASIC
which specifies the PIM status in the switch. The parameters for this page are shown in
Table
7-127.
Table 7-127. PIM Basic Settings Page Parameters
Parameter
PIM Status
PIM V6 Status
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-159. PIM Basic Settings Page
S
tab brings up the PIM B
ETTINGS
Description
This parameter allows you to enable or disable the PIM status in the
switch.
This parameter allows you to enable or disable the PIM V6 status in the
switch.
S
ASIC
7-179
page
(Figure
ETTINGS
7-159),