Figure 7-43. Qos Policymap Settings Page; Table 7-31. Qos Policymap Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
QOS Policymap Settings
Clicking the P
OLICYMAP
which is used to specify action for a specified classmap. The parameters for this page
are shown in
Table
Table 7-31. QOS Policymap Settings Page Parameters
Parameter
Policy Map ID
Class Map ID
Traffic Rate
In-Profile Action
Out-Profile Action
In-Profile Action Value
Out-Profile Action Value
Figure 7-43. QOS Policymap Settings Page
tab brings up the QOS P
7-31.
Description
This parameter specifies the unique ID for Policymap. The value ranges
between 1 and 65535.
This parameter specifies the C
This parameter specifies the T
This parameter specifies the action to be applied on matched data, and
can be specified as either Policy DSCP or Policy Precedence.
This parameter specifies the action to be applied on out-of-profile data, and
can be specified as either Policy DSCP or Drop.
The I
-P
A
N
ROFILE
CTION
from 0 to 63 for IP Precedence.
The O
-P
A
UT
ROFILE
for DSCP.
S
OLICYMAP
M
ID to associate with Policymap.
LASS
AP
R
RAFFIC
ATE
V
can be specified from 0 to 7 for DSCP, or
ALUE
V
can be specified as Drop or from 0 to 63
CTION
ALUE
7-50
page
(Figure
ETTINGS
of data that has to be applied.
7-43),
Advertisement
Table of Contents
