Stack Details; Figure 7-50. Stack Details Page; Table 7-36. Stack Details Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Table 7-35. Stack Configuration Page Parameters (Continued)
Parameter
Priority
Stacking
Stack Details
Clicking the S
TACK
displays stacking details. The parameters for this page are shown in
Parameter
Self Status
Stack Ports
Switch ID
Stack IP
Stack MAC
Description
This parameter chooses the priority for this switch in the Stacking Master
selection. It could be configured as Preferred Master, Backup Master or
Preferred Slave.
This parameter enables or disables stacking.
NOTE: Any change in stacking status requires a reboot of the switch.
Figure 7-50. Stack Details Page
D
tab brings up the S
ETAILS
Table 7-36. Stack Details Page Parameters
Description
This is the number of stacking ports configured in this switch.
This parameter is used to specify the switch identifier of this switch.
This parameter is used to specify the IP address of this switch. This IP
address is used to communicate between stack member switches.
This parameter is used to specify the MAC address of this switch. This
MAC address is used to communicate between stack member switches.
D
TACK
ETAILS
7-60
page
(Figure
7-50), which
Table
7-36.
Advertisement
Table of Contents
