Table 7-38. Port Basic Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Clicking the B
ASIC
which allows you to configure port status and mode information. This page also helps
configuring priority and MTU. The parameters for this page are shown in
Table 7-38. Port Basic Settings Page Parameters
Parameter
Port
Link status
Admin State
Default User Priority
Switch Port
Switch Port Mode
MTU
Link Up/Down Trap
Chapter 7: Layer 2/3 Ethernet Switch Firmware
S
tab brings up the P
ETTINGS
Description
This displays the port number.
This column shows the physical link status as an UP or Down arrow. A
green up arrow indicates that the status of the port is up, while the red
down arrow indicates that the status of the port is down.
This parameter allows you to administratively configure the admin state as
Up or Down.
This parameter allows you to set the priority from 0 to 7.
By default all ports are switch ports for layer 2 switching. To configure a
port as a layer 3 routed port, choose No.
Use this control allows to set the access mode as either Trunk or Hybrid.
This sets the MTU value. The Minimum is 90 and Maximum is 16338. A
port must be administrativly down in order to change the MTU. Jumbo
frames of up to 9216 bytes are supported on 1G links. Jumbo frames of up
to 16338 bytes are supported on 10G links.
This parameter enables or disables SNMP trap generation for port up and
down events.
B
S
ORT
ASIC
7-67
page
(Figure
ETTINGS
Table
7-56),
7-38.
Advertisement
Table of Contents
