2 System Configuration
2.1 Management IP
The SSE-G3548S/R comes with DHCP IP settings for default IP management.
2.1.1 Static Management IP Address
The IP address command can be used to manually configure the management interface IP address.
Follow the steps below to manually configure the management interface IP address.
Step Command
Step 1
configure terminal
Step 2
ip address [<ip-address> | <ip-address>/prefix-
length] [<subnet-mask>]
Step 3
end
Step 4
show ip interface
The manual IP address configuration is saved automatically as part of the start-up config.
The "no ip address" command resets the switch IP address to 0.0.0.0.
The example below shows the commands used to configure the management interface IP address
manually.
SMIS# configure terminal
SMIS(config)# ip address 192.168.1.10
SMIS(config)# end
2.1.2 DHCP
Supermicro switches can be configured to obtain the management IP address through DHCP protocol. In
this case, the switch acts as a DHCP client and obtains an IP address for any DHCP server on the LAN.
DHCP is the default management IP address mode.
Follow the steps below to obtain the management interface IP address dynamically from a DHCP server.
Supermicro SSE-F3548S/SSE-F3548SR Configuration User's Guide
Description
Enters the configuration mode
Configure the management interface IP
address manually.
ip-address – A valid IPv4 Address.
ip-address/prefix-length - A valid IPv4
Address with a prefix length of 1-32.
subnet-mask – A valid IP subnet mask.
Exits the configuration mode.
Displays the management interface IP
configuration.
16