Acl; Mac Based Acl; Ip Standard Acl; Ip Extended Acl - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
ACL
The ACL link allows you to configure the Access Control List for the switch. You can
configure ACL on the following three pages:
•
"MAC Based ACL" on page 7-27
•
"IP Standard ACL" on page 7-28
•
"IP Extended ACL" on page 7-29
MAC Based ACL
Clicking the M
AC
which displays the various parameters to configure the MAC Access List. The
parameters for this page are shown in
Table 7-11. MAC ACL Configuration Page Parameters
Parameter
ACL Number
Source and Destination
MAC
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-22. MAC ACL Configuration Page
ACL tab brings up the M
Description
This parameter specifies a unique ID for the access list.
These fields specify both the Source MAC Address and Destination MAC
Address, for which the access list must be applied. Both the Source and
Destination MAC Addresses must be configured for the status of the
access list to be active.
ACL C
AC
ONFIGURATION
Table
7-11.
7-27
page
(Figure
7-22),
Advertisement
Table of Contents
