Ripng; Rip6 Interface; Figure 7-115. Rip6 Interface Configuration Page; Table 7-88. Rip6 Interface Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
RIPng
The RIP6 link allows you perform RIPv6 related configuration for the switch. This can be
accomplished through the following two pages:
•
"RIP6 Interface" on page 7-129
•
"Filters" on page 7-130
RIP6 Interface
Clicking the RIP6 I
(Figure
7-115). The parameters for this page are shown in
Table 7-88. RIP6 Interface Configuration Page Parameters
Parameter
Interface ID
Status
Prof ID
Metric Offset
Def Rt Adv
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-115. RIP6 Interface Configuration Page
tab brings up the RIP6 I
NTERFACE
Description
Specifies the Interface Id for which RIPv6 needs to be configured.
This parameter specifies the administration status of the interface.
This parameter indicates the Index of the Address Profile entry.
This parameter specifies the metric for the routes that are being
re-distributed.
This parameter indicates the default router lifetime to be placed in the
Router Advertisements sent on the interface.
NTERFACE
7-129
C
ONFIGURATION
Table
7-88.
page
Advertisement
Table of Contents
