Figure 7-137. Rrd Basic Settings Page; Table 7-110. Rrd Basic Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
RRD Basic Settings
Clicking the B
ASIC
(Figure
7-137). The parameters for this page are shown in
Table 7-110. RRD Basic Settings Page Parameters
Parameter
RRD Status
AS Number
Router ID
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-137. RRD Basic Settings Page
S
tab brings up the RRD B
ETTINGS
Description
By enabling this parameter, Route Re-distribution can be enabled in the
switch.
This parameter is used to configure the Router AS number to which this
switch belongs.
This parameter represents the Router ID of the switch.
ASIC
7-157
S
page
ETTINGS
Table
7-110.
Advertisement
Table of Contents
