Figure 7-101. Ipv6 Interface Settings Page; Table 7-75. Ipv6 Interface Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-74. IP6 Route Configuration Page Parameters (Continued)
Parameter
Routing Protocol
Gateway
Interface
Distance (Metric)
IPv6 Interface
Clicking the IP
V
(Figure
7-101), which displays the various parameters for the IPv6 Interface. The
parameters for this page are shown in
Table 7-75. IPv6 Interface Settings Page Parameters
Parameter
Port
Admin
Oper
RA Status
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter indicates the routing protocol through which the route was
learnt, if not manual. This cannot be configured.
This parameter specifies the Next Hop Gateway to reach the IP address.
This parameter indicates the outgoing interface.
This parameter denotes metric value of the destination.
Figure 7-101. IPv6 Interface Settings Page
6 I
tab brings up the IP
NTERFACE
Description
This parameter specifies the Index of the VLAN interface.
This parameter indicates the Administrative Status of IPv6 on the Interface.
This parameter specifies the Operational Status of IPv6 on the given
Interface, which is a read-only field.
This parameter indicates the Router Advertisement status on the Interface.
6 I
V
NTERFACE
Table
7-75.
7-115
S
page
ETTINGS
Advertisement
Table of Contents
