Figure 7-163. Pim Threshold Configuration Page; Table 7-131. Pim Threshold Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Threshold
Clicking the T
HRESHOLD
(Figure
7-163). The parameters for this page are shown in
Table 7-131. PIM Threshold Configuration Page Parameters
Parameter
Group Threshold
Source Threshold
Switching Period
RP Threshold
RP Switching Period
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-163. PIM Threshold Configuration Page
tab brings up the PIM T
Description
This parameter is a bits-per-second (BPS) value that when it exceeds a
certain value, initiates source specific counters for a particular group.
This parameter is a bits-per-second (BPS) value that when exceeds a
certain value, initiates switching to shortest path tree.
This parameter specifies the time interval that the data rate is monitored
for, initiating the counters or for switching to SPT.
When the number of registered packets received exceeds this threshold
value, RP initiates switching to SPT.
This parameter specifies the time interval for which the registered packets
are monitored to initiate switching to SPT.
HRESHOLD
7-183
C
page
ONFIGURATION
Table
7-131.
Advertisement
Table of Contents
