Pool Settings; Figure 7-107. Dhcp Pool Settings Page; Table 7-81. Dhcp Pool Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Pool Settings
Clicking the P
OOL
which allows you to configure the IP address pool that can be used by the DHCP server
to allocate IP addresses. The parameters for this page are shown in
Table 7-81. DHCP Pool Settings Page Parameters
Parameter
Pool ID
Network
Subnet Mask
Start IP
End IP
Lease Time
Utilization Threshold
Status
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-107. DHCP Pool Settings Page
S
link brings up the DHCP P
ETTINS
Description
This parameter specifies the pool ID to index among the different subnet
pools configured.
This parameter specifies the subnet of the IP address in the pool.
This parameter specifies the subnet mask of the IP address in the pool.
This parameter specifies the first IP address in the address pool that is
used for dynamic allocation by the DHCP server.
This parameter specifies the last IP address in the address pool that is
used for dynamic allocation by the DHCP server.
This parameter specifies the time interval for which the IP address is valid.
This parameter specifies the DHCP Pool Utilization Threshold value.
This parameter specifies the status of the entry.
S
OOL
7-121
page
(Figure
ETTINGS
Table
7-81.
7-107),
Advertisement
Table of Contents
