Port Settings; Figure 7-85. La Port Settings Page; Table 7-62. La Port Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Port Settings
Clicking the P
ORT
which configures LA properties at a per-port level. The parameters for this page are
shown in
Table
Parameter
Port
Port Priority
Mode
Activity
Timeout
Figure 7-85. LA Port Settings Page
S
tab brings up the LA P
ETTINGS
7-62.
Table 7-62. LA Port Settings Page Parameters
Description
This parameter specifies the Interface Index.
This parameter specifies the priority value of the Port.
This parameter specifies the various port modes, such as LACP, Manual or
Disable.
This parameter specifies whether the Port LACP activity is Active or
Passive.
This parameter sets the time within which LACP PDUs must be received
on a port to avoid timing out of the Aggregated Link. If a Long timeout is
chosen then the ports will time out of the Port Channel in 90-seconds. If a
Short timeout is chosen then the ports will time out of the Port Channel in
3-seconds.
S
ORT
ETTINGS
7-98
page
(Figure
7-85),
Advertisement
Table of Contents
