Qos; Qos Basic Settings; Qos Classmap Settings; Qos Policymap Settings - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Table 7-28. History Control Configuration Page Parameters (Continued)
Parameter
Buckets Granted
Status
QoS
The QoS link of the System page opens the QoS Basic Settings page. This page allows
you to configure QoS through following pages:
•
"QOS Basic Settings" on page 7-48
•
"QOS Classmap Settings" on page 7-49
•
"QOS Policymap Settings" on page 7-50
•
"COSQ Scheduling Algorithm" on page 7-51
•
"COSQ Weight and Bandwidth Configuration" on page 7-52
QOS Basic Settings
Clicking the B
ASIC
which allows you to configure QOS basic settings parameters. The parameters for this
page are shown in
Description
Denotes the number of buckets granted for collecting the RMON statistics.
This parameter specifies the status of the History Control entry as either
Valid or Invalid.
Figure 7-41. QOS Basic Settings Page
S
tab brings up the QOS B
ETTINGS
Table
7-29.
S
ASIC
7-48
page
(Figure
ETTINGS
7-41),
Advertisement
Table of Contents
