Switchport General Ingress-Filtering Disable - Dell PowerConnect 8024 Cli Reference Manual

User Guidelines
You can use this command to change the egress rule (for example, from tagged to untagged)
without first removing the VLAN from the list.
Example
The following example shows how to add VLANs 1, 2, 5, and 8 to the allowed list.
console(config-if-1/g8)#switchport general allowed vlan add
1,2,5,8 tagged

switchport general ingress-filtering disable

Use the switchport general ingress-filtering disable command in Interface Configuration mode
to disable port ingress filtering. To enable ingress filtering on a port, use the no form of this
command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to enables port ingress filtering on 1/g8.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport general ingress-filtering
disable
510
VLAN Commands