Ipv6 Enable; Ipv6 Gateway - Dell PowerConnect 8024 Cli Reference Manual

console(config)#no ipv6 address dhcp
console(config)#no ipv6 address autoconfig
console(config)#no ipv6 address 2003::6/64
console(config)#no ipv6 address 2001::/64 eui64
console(config)#no ipv6 address

ipv6 enable

Use the ipv6 enable command to enable IPv6 on the management interface. Use the "no" form
of this command to disable IPv6 on the management interface.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 is enabled on the management interface by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable

ipv6 gateway

Use the ipv6 gateway command to configure an IPv6 gateway for the management interface.
Use the "no" form of this command to reset the gateway to the default.
303
IP Addressing Commands