Ip Igmp Last-Member-Query-Count - Dell PowerConnect 8024 Cli Reference Manual

User Guidelines
This command has no user guidelines.
Example
The following example globally enables IGMP.
console(config)#ip igmp

ip igmp last-member-query-count

Use the ip igmp last-member-query-count command in Interface Configuration mode to set
the number of Group-Specific Queries sent before the router assumes that there are no local
members on the interface.
Syntax
count
ip igmp last-member-query-count
no ip igmp last-member-query-count
count — Query count. (Range: 1-20)
•
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets 10 as the number of VLAN 2 Group-Specific Queries.
console#configure
console(config)#interface vlan 2
console(config-if-vlan2)#ip igmp last-member-query-count 10
console(config-if-vlan2)#no ip igmp last-member-query-count
588
IGMP Commands