Ipv6 Mld Last-Member-Query-Count; Ipv6 Mld Last-Member-Query-Interval - Dell PowerConnect 8024 Cli Reference Manual

ipv6 mld last-member-query-count

The ipv6 mld last-member-query-count command sets the number of listener-specific queries
sent before the router assumes that there are no local members on the interface. Use the "no"
form of this command to set the last member query count to the default.
Syntax
ipv6 mld last-member-query-count
no ipv6 mld last-member-query-count
last-member-query-count — Query count (Range: 1–20).
•
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-count 5

ipv6 mld last-member-query-interval

The ipv6 mld last-member-query-interval command sets the last member query interval for the
MLD interface, which is the value of the maximum response time parameter in the group-
specific queries sent out of this interface. Use the "no" form of this command to set the last
member query interval to the default.
Syntax
ipv6 mld last-member-query-interval
no ipv6 mld last-member-query-interval
last-member-query-interval — The last member query interval (Range: 0–65535
•
milliseconds).
Default Configuration
The default last member query interval is 1 second.
last-member-query-count
last-member-query-interval
IPv6 Routing Commands
661