Deny (Management) - Dell PowerConnect 8024 Cli Reference Manual

Management ACL Commands
This chapter explains the following commands:
•

deny (management)

• management access-class
• management access-list
• permit (management)
• show management access-class
• show management access-list
deny (management)
Use the deny command in Management Access-List Configuration mode to set conditions for
the management access list.
Syntax
interface-number
deny [ethernet
priority
[priority ]
ip-address
deny ip-source
id number
| port-channel
interface-number — A valid Ethernet-routed port number.
• ethernet
vlan vlan-id — A valid VLAN number.
•
number — A valid routed port-channel number.
• port-channel
ip-address — Source IP address.
•
mask — Specifies the network mask of the source IP address.
• mask
prefix-length — Specifies the number of bits that comprise the source IP address prefix.
• mask
The prefix length must be preceded by a forward slash (/). (Range: 0–32)
service — Indicates service type. Can be one of the following: telnet, ssh, http, https,
• service
tftp, snmp, or sntp.
priority — Priority for the rule. (Range: 1–64)
• priority
vlan-id
| vlan | port-channel
mask prefix-length
[mask |
service
] [service ] [priority
number
] [service
interface-number
] [ethernet
priority
]
Management ACL Commands
63
service
]
vlan-
| vlan
959