Ip Mcast Boundary; Ip Mroute - Dell PowerConnect 8024 Cli Reference Manual

• show ip pimsm rp mapping

ip mcast boundary

Use the ip mcast boundary command in Interface Configuration mode to add an administrative
scope multicast boundary specified by
administrative boundary is applicable.
mask.
Syntax
ip mcast boundary
no ip mcast boundary
groupipaddr — IP address of multicast group. Valid range is 239.0.0.0 to 239.255.255.255.
•
mask — IP mask of multicast group.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5
255.255.255.255

ip mroute

Use the ip mroute command to create a static multicast route for a source range. Use the "no"
form of this command to delete a static multicast route.
Syntax
ip mroute
no ip mroute
706
Multicast Commands
groupipaddr mask
groupipaddr mask
source-address source-mask rpf-address preference
source-address source
groupipaddr mask
and
groupipaddr
is a group IP address and
for which this multicast
mask
is a group IP