ip rip
Use the ip rip command in Interface Configuration mode to enable RIP on a router interface.
Use the no form of the command to disable RIP on the interface.
Syntax
ip rip
no ip rip
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-vlan2)#ip rip
console(config-if-vlan2)#no ip rip
ip rip authentication
Use the ip rip authentication command in Interface Configuration Mode to set the RIP Version
2 Authentication Type and Key for the specified interface. Use the no form of the command to
return the authentication to the default value.
Syntax
ip rip authentication {none | {simple
no ip rip authentication
key — Authentication key for the specified interface. (Range: 16 bytes or less)
•
•
encrypt — Specifies the Ethernet unit/port of the interface to view information.
•
key-id — Authentication key identifier for authentication type encrypt. (Range: 0-255)
Default Configuration
This command has no default configuration.
850
Routing Information Protocol Commands
key
key key-id
} | {encrypt
}}