Default Configuration
The guest VLAN is disabled on the interface by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Configure the guest VLAN before using this command.
Example
The following example sets the guest VLAN on port 1/g2 to VLAN 10.
console(config-if-1/g2)#dot1x guest-vlan 10
dot1x unauth-vlan
Use the dot1x unauth-vlan command in Interface Configuration mode to specify the
unauthenticated VLAN on a port. The unauthenticated VLAN is the VLAN to which
supplicants that fail 802.1X authentication are assigned.
Syntax
vlan-id
dot1x unauth-vlan
no dot1x unauth-vlan
vlan-id — The ID of a valid VLAN to use for unauthenticated clients (Range: 0-4093).
•
Default Configuration
The unauthenticated VLAN is disabled on the interface by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Configure the unauthenticated VLAN before using this command.
Example
The following example set the unauthenticated VLAN on port 1/g2 to VLAN 20.
console(config-if-1/g2)#dot1x unauth-vlan 20
546
802.1X Commands