no area
area-id
area-id — Identifies the OSPF not-so-stubby-area. (Range: 0–4294967295)
•
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures not-so-stubby-area 10 as an NSSA.
console(config)#router ospf
console(config-router)#area 10 nssa
area nssa default-info-originate
Use the area nssa default-info-originate command in Router OSPF Configuration mode to
configure the metric value and type for the default route advertised into the NSSA. The metric
type can be comparable (nssa-external 1) or non-comparable (nssa-external 2). Use the no form
of the command to return the metric value and type to the default value.
Syntax
area-id
area
area-id
no area
area-id — Identifies the OSPF NSSA to configure. (Range: IP address or decimal from
•
0–4294967295)
integer — Specifies the metric of the default route advertised to the NSSA. (Range:
•
1–16777214)
•
comparable — A metric type of nssa-external 1
•
non-comparable — A metric type of nssa-external 2
Default Configuration
If no metric is defined, 10 is the default configuration.
730
OSPF Commands
nssa
nssa default-info-originate [
nssa default-info-originate
integer
] [ comparable | non-comparable ]