Show Ip Ospf - Dell PowerConnect 8024 Cli Reference Manual

Command Mode
Global Configuration mode.
User Guidelines
The command prompt changes when the router ospf command executes.
Example
The following example enters into router OSPF mode.
console(config)#router ospf
console(config-router)#

show ip ospf

Use the show ip ospf command to display information relevant to the OSPF router. This
command has been modified to show additional fields.
Syntax
show ip ospf
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
Some of the information below displays only if you enable OSPF and configure certain features.
The following fields may be displayed:
Router ID
OSPF Admin Mode
ASBR Mode
760
OSPF Commands
A 32-bit integer in dotted decimal format identifying the router about which
information is displayed. This is a configured value.
Shows whether the administrative mode of OSPF in the router is enabled or
disabled. This is a configured value.
Reflects whether the ASBR mode is enabled or disabled. Enable implies that the
router is an autonomous system border router. Router automatically becomes an
ASBR when it is configured to redistribute routes learned from other protocol.
The possible values for the ASBR status is enabled (if the router is configured to
re-distribute routes learned by other protocols) or disabled (if the router is not
configured for the same).