Dell PowerConnect 8024 Cli Reference Manual page 74

VLAN
Command
dvlan-tunnel ethertype
interface vlan
interface range vlan
mode dvlan-tunnel
name
protocol group
protocol vlan group
protocol vlan group all
show dvlan-tunnel
show dvlan-tunnel interface
show interfaces switchport
show port protocol
show switchport protected
show vlan
show vlan association mac
show vlan association subnet
switchport access vlan
switchport forbidden vlan
switchport general acceptable-
frame-type tagged-only
switchport general allowed vlan
switchport general ingress-filtering
disable
switchport general pvid
74
Command Groups
Description
Configures the EtherType for the interface.
Enters the interface configuration (VLAN) mode.
Enters the interface configuration mode to configure
multiple VLANs.
Enables Double VLAN tunneling on the specified interface IC
Configures a name to a VLAN.
vlanid
Attaches a to the protocol-based VLAN identified by
groupid
.
Adds the physical unit/port interface to the protocol-based
groupid
VLAN identified by
Adds all physical unit/port interfaces to the protocol-based
groupid
VLAN identified by
Displays all interfaces enabled for Double VLAN Tunneling. PE
Displays detailed information about Double VLAN
Tunneling for the specified interface.
Displays switchport configuration.
Displays the Protocol-Based VLAN information for either
the entire system or for the indicated group
Displays protected group/port information.
Displays VLAN information.
Displays the VLAN associated with a specific configured
MAC address.
Displays the VLAN associated with a specific configured IP
subnet.
Configures the VLAN ID when the interface is in access
mode.
Forbids adding specific VLANs to a port.
Discards untagged frames at ingress.
Adds or removes VLANs from a port in General mode.
Disables port ingress filtering.
Configures the PVID when the interface is in general mode. IC
.
.
Mode*
GC
GC
GC
IC
VLAN
IC
GC
PE
PE
PE
PE
PE
PE
PE
IC
IC
IC
IC
IC