Syntax
exit
Default Configuration
MST configuration.
Command Mode
MST mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to exit the MST configuration mode and save changes.
console(config)#spanning-tree mst configuration
console(config-mst)#exit
instance (mst)
Use the instance command in MST mode to map VLANS to an MST instance.
Syntax
instance-id
instance
{add | remove} vlan
instance-ID — ID of the MST instance. (Range: 1-15)
•
vlan-range — VLANs to be added to the existing MST instance. To specify a range of VLANs,
•
use a hyphen. To specify a series of VLANs, use a comma. (Range: 1-4093)
Default Configuration
VLANs are mapped to the common and internal spanning tree (CIST) instance (instance 0).
Command Mode
MST mode
User Guidelines
Before mapping VLANs to an instance use the spanning-tree mst enable command to enable
the instance.
All VLANs that are not explicitly mapped to an MST instance are mapped to the common and
internal spanning tree (CIST) instance (instance 0) and cannot be unmapped from the CIST.
vlan-range
Spanning Tree Commands
455